Posted by Mike W on September 26, 2016
My task was to bend clear 4" pvc pipe that would be used to demonstrate flow of liquid in a facility. Since I had not bend this pipe before and needed to achieve 15 and 30 degree radius bends I decided to use our method of inserting smaller pieces of flexible metal hose into the pipe and then placing the PVC Bendit in the center and plug the ends with paper. This method helps to heat the pipe more uniformly.
We used 4" pipe insulation to help keep the heat in the pipe.
It took about 30 minutes to get the pipe to near the correct temperature so it would be soft enough to bend. I then carefully began bending the pipe and found it was not uniformly heated so I rotated the pipe 180 degrees, waited a few minutes and finished the bend. Shown below is a straight pipe and then ones we bent. ot